| Statistics |
Total online: 1 Guests: 1 Users: 0 |
|
 | |  |
| | Home » Repair PC's components » ASUS K8N MOTHERBOARD REPAIR WITHOUT RESET INSTANCE
16:05 ASUS K8N MOTHERBOARD REPAIR WITHOUT RESET INSTANCE |
Lay before this board for a long time, and we have no CPU can be measured, naturally do not know good or bad
  Repair this board, learned the geography of some powerbecause there is no process taking a lot of costly mistakes.Is a power failure situation, there is no reset, the system continues to remain reset state, master P, C, R principles repair.
 Saw the unconscious is not reset immediately check the CPU working conditions, digging miles! CPU is not powered, also check the CPU power supply of the relevant line, did not send EN to the PWM chip, no wonder no Vcore, and there is no VID signal, obviously the first hurdle (North Bridge) hung up, K8 architecture since there is no northbridge ( actually integrated within the CPU), memory, first check the power supply, after investigation did not, went to the CPU VDDQ also found no problem, some are originally went to the North Bridge voltage CPU, the checked , some are normal, but some did not supply the associated, these non-voltage power supply with the South Bridge (integrated bridge), a common share, and truly suffered. South Bridge Voltage 1.2V No, there are 1.6V, and also did not, did not get.
    G had to say off the voltage so low, middle resistor is larger, the result is still the same. (Not seriously run the line, simply has noresistance)Would like to break it up ...... for the one, the result is still the same.
 Grew more and more strange, so he changed back. Read the next, even with transistors? (Lost time did not knowwhere the transistor is doing.) Volume a bit reference voltage of 3.3V down the top, but through the resistor divider, the voltage actually gone!
  The other was a resistance to ground, figured, there mustobviously 1.2V ah! How not.
  Way to play a little resistance, and no case of low impedance ah!
 Simply removed the transistor ..... really amazing, 1.2V there!
Later, after inspection, not a bad transistor ...........
Then check the other one for MOS, Fengyun MOS, is to provide1.6V power supply to the South Bridge, but it did not even out?
D voltage
S voltage
G is the voltage again, to the side, has been suspected of MOSdestroyed.
Altogether removed, really, bad!
MOS checked, confirm that it is bad.As sure is bad, and from the waste board put to find a good product.
Power on again, and she run yards
Measure the voltage.
1.2V appeared.
1.6V is also normal.
Bios running, repair succesfull! |
|
Category: Repair PC's components |
Views: 1108 |
|
| |
 | |  |
|
|
| |
